Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operation (see page 26)
Dimensions (see page 27)
Flow diagram (see page 27)
Fault
Insufficient water
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
Spout temperature does not cor-
respond with temperature set
Temperature regulation not possible
Instantaneous heater didn't work with
thermostat
Shower or spout dripping
English
Cause
- Supply pressure inadequate
- Regulator filter dirty (#96922000)
- Shower filter seal dirty
- Backflow preventers dirty or leaking - Clean backflow preventers, ex-
- Thermostat has not been adjusted
- Hot water temperature too low
- thermo cartridge calcified
- Filters are dirty
- check valve hasn't moved back
- Flow limiter in handshower isn't
removed
- Ecostop safety set removed.
(#95042000)
- Dirt or sedimentation on valve seat,
shut-off unit damaged
Assembly see page 20
Spare parts (see page 29)
Cleaning (see page 28)
Test certificate (see page 32)
Remedy
- Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Clean filter in front of the mixer
and on the MTC-thermo cartridge
(#96922000)
- Clean filter seal between shower
and hose
change if necessary
- Adjust thermostat
- Increase hot water temperature to
42 ºC to 65 ºC
- Exchange thermo cartridge
- Clean the filter / exchange filter
- Exchange check valves
- Remove flow limiter
- Remove Ecostop safety set
(#95042000)
- Clean or exchange shut-off unit
5
Advertenties
Inhoudsopgave
