Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
3. Stick adhesive strips to the back of the adapter plate at
the top.
4. Repeat steps 2 and 3 on the right, bottom and left (see
illustrations).
5. Press the adapter plate against the wall for a few seconds,
lined up straight and with the adhesive strips facing the
wall.
> The adapter plate is now attached to the wall.
Fastening the adapter plate with screws
1. Make sure that the section of the wall you wish to attach
the bracket to is flat and suitable for a drilling depth of
40 mm.
2. Mark the locations of the two drilled holes, horizontally
next to each other and 60 mm apart.
3. Use a 5-mm drill bit to drill holes at the marked locations
(drilling depth: 40 mm).
4. Push the wall plugs provided into the drilled holes.
5. If necessary, align the adapter plate to the thickness of the
switch frame (only if you are not using the rotary button
frame included in the delivery).
6. Attach the adapter plate to the wall using the screws
provided.
7. Tighten the screws hand-tight using a Phillips screwdriver.
> The adapter plate is now attached to the wall.
EN
19
Advertenties
