Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - Stiebel Eltron SHW 200 ACE Handleiding Voor Bediening En Installatie
Gesloten staande warmwaterboiler
Verberg thumbnails
Zie ook voor SHW 200 ACE:
- Handleiding voor bediening en installatie (14 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Safety
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
8.
Appliance description
8.1
Standard delivery
Delivered with the appliance:
- Thermometer (delivered inside the control panel)
- Cylinder casing (delivered fixed to the thermal insulation)
8.2
Accessories
Required accessories
Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against unacceptable excess pressure.
Further accessories
If it is not possible to fit an anode rod from above, install a seg-
mented signal anode.
9.
Preparations
9.1
Installation site
Always install the appliance in a room free from the risk of frost
and near the draw-off point, and secure the appliance to the floor.
18
| SHW ACE
10. Installation
10.1 Fitting the cylinder casing and DHW circulation
line if required
Note
Fit the cylinder casing before making the water connec-
tion and, if necessary, the DHW circulation line or the
flanged immersion heater.
A DHW circulation line can be fitted to the "DHW circulation"
connection (see chapter "Specification / Dimensions and connec-
tions"). Alternatively, the "DHW circulation" connection can be
used to connect a thermometer.
3
2
1 Connection "DHW circulation"
2 Cylinder casing
3 Zip fastener
Installation
f Fit the cylinder casing.
f Fit the cable grommet and control panel cover.
f Push on the temperature selector.
f If you use the "DHW circulation" connection to install a DHW
circulation line, you need to cut an opening in the cylinder
casing near the connection (indentation in the foam) for the
DHW circulation line.
f Remove the thermal insulation near the connection.
f Route the DHW circulation line through the aperture in the
cylinder casing and fit the DHW circulation line.
f Insulate the "DHW circulation" connection.
1
www.stiebel-eltron.com
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
