Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
13.5.2
units are needed.
c) Do not remove the feet from the bottom of the appliance.
d) Do not cover or obstruct any openings in the appliance.
e) Covering the ventilation slots may cause damage to the appliance.
f) Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
2) Insert the power plug into a normal household outlet; check that voltage and
frequency of the appliance (see appliance rating label) matches that of the
household electrical supply.
13.5.3
The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
Clean the door and the sealing surfaces of the device.
Set the radio, the television, etc as far as possible away from the device.
Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
Use a properly installed antenna for the receiver, to ensure good reception.
13.6 Assembling the accessories
13.6.1
1 Hub (underside)
2 Glass turntable
3 Turntable drive
4 Rolling ring
Assemble the glass turntable as follows:
Insert the rolling ring
Installation of the appliance
Avoiding radio interference
Glass turntable
1) Select a level surface
providing enough distance
between the ventilation slots and
walls or other units.
a) The surface for placing the
appliance must be at least 85 cm
above the floor.
b) The rear of the appliance must
be facing a wall. Above the
appliance a clearance of 30 cm is
needed, and on the sides at least
20 cm distance to other walls or
60
Advertenties
Inhoudsopgave
