Inhoudsopgave
Advertenties
2. Install the tap handle connect the tap, make sure both end fit together perfectly.
(Show as Figure 4)
3. Set the water drip tray into the notch provided. (Show as figure 5)
4. Open the beer cooler with 60-80N strength.
Note: Do not connect or disconnect the electric plug when your hands are wet. Before
use it, make sure the voltage is conformity with plug mark, and check whether the
power cord is well connected or not; if not, please don't use it, and call service center;
5. Put 800ml water into the cooling cavity or pour the water to the max mark (Show as
figure 6) (It can work without water, but it can't display the best performance)
Note: Make sure the drain switch is at "Off" position, and no extra objects in the
cooling cavity.
The max water level line (800ml)
Make sure the drain switch is at "OFF" position.
Figure 5
Figure 6
6. Place the ready-to-use drum in the tank of the appliance, connect the inlet hose to
the drum.
NOTES: Check that the connection of the valve system is correct and undamaged.
Make sure that the tap valve is in the closed position.
7. Plug the beer cooler.
Note: Do not connect or disconnect the electric plug when your hands are wet. Before
use it, make sure the voltage is conformity with plug mark, and check whether the
power cord is well connected or not; if not, please don't use it, and call service center.
8. Close the top cover of the beer cooler.
9. Turn on the power switch to "I" position to power on the beer cooler. (While "0"position
Advertenties
Inhoudsopgave
