Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UK
LED 2 is lit when there is a fault.
4.2. Turn the heat pump on/off
Press
5 seconds, and then changes to show the current water inlet temperature.
Press
Please note that the heat pump start-up time can be up to 3 minutes.
4.3. Setting the water outlet temperature
Press
Press
4.4. Parameter control
Parameter
Ambient temperature
Water temperature
Press
Press
Press
5.
Maintenance
• You should regularly check the water supply system in order to prevent air getting into
the system which can reduce the water flow, as it will reduce the performance and
stability of the heat pump.
• Clean the pool/hot tub and filter system on a regular basis in order to avoid damage to
the device resulting from a dirty and clogged filter.
• You must empty the water from the heat exchanger if the heat pump is taken out of
58
to turn on the heat pump. The LED display shows the set water temperature for
again to switch off the heat pump.
to adjust the water outlet temperature (interval: 10-42 °C).
or
to save the settings and exit the menu.
Code
d0
d1
to access the parameter control. Press
again and the measured value will be displayed.
to save and exit the menu.
MV-1295-1296-1297-10-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
Interval Note
0—99
Will flash and display
0—99
Will flash and display
or
oU
if outside interval
oU
if outside interval
d0
d1
to select code
/
.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
