Download Print deze pagina

Instructions For Use; Control Buttons On The Led Panel - Swim & Fun 1295 Gebruikershandleiding

Verberg thumbnails

100

Inhoudsopgave

Advertenties

Beschikbare talen

which provide electrical protection.

NOTE

The heat pump has no pump. In order to be able to heat the water, the filter pump

must be in operation. It is the filter pump that directs the water through the heat

pump and the Heat Splasher cannot start if the water is not circulating.

3.6 Initial procedure

When everything is connected and has been checked, go through the following points:

• Turn on the filter pump. Check for leaks and make sure that the water is flowing to and

from the pool.

• Connect the power to the heat pump. The unit will start when the time delay has ex-

pired.

• After a few minutes, check if the air that is being blown out of the unit is cooler.

• Check that the heat pump stops automatically when the filter pump is switched off.

3.7 Time delay

In order to protect the electrical circuit, the heat pump has a built in 3-minute start-up

delay. This is also in order to avoid excessive wear and tear of switches. The unit starts

automatically when the time delay has expired. Even a short power outage will trigger the

start-up delay and prevent the device restarting immediately. Further power cuts within the

same 3-minute period will not further extend the start-up delay.

NOTE

The heat pump must be earthed. We recommend the purchase of a Schuko plug.