Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
•
Connect the suction hose to the water collection device and the
water hose to the core drill.
•
Turn the green selector switch to the "AUTO" switch position.
•
Select the desired mode on the toggle switch - normally "Circulation
•
Open the ball valve on the water supply of the core drill. You can
regulate the water quantity continuously via the ball valve.
•
Switch on the core drill. The water recycling system now switches on
automatically. Water is transported to the core bit via the pump. At
the same time, drilling mud is sucked off.
•
Check the water level in the container regularly and top up with
water in good time.
Change filter bag
•
Open the two catches on the container and remove the motor head.
•
Carefully remove the filter bag from the filter bag holder.
Attention!
Sharp or pointed objects that have pierced through the filter bag may
present a risk of injury.
Check to ensure that the filter bag has not been pierced by sharp or
pointed objects.
•
Close the filter bag with the cap that's attached to the bag.
•
Dispose of the filter bag according to the legal requirements.
•
Insert a new filter bag.
•
Place the motor head on the container and close the catches.
Empty / clean the container
•
Open the two catches on the container and remove the motor head.
•
Remove the filter bag
•
Empty the waste material container
•
Clean the container with clear water. Also rinse the hoses with
clear water.
•
Insert a new filter bag.
•
Place the motor head on the container and close the catches.
Clean exhaust air filter
•
Remove the filter cassette on the back of the motor head and take
out the exhaust air filters.
•
Clean (vacuum, wash out) or replace the exhaust air filter.
Operation
17
Advertenties
Inhoudsopgave
