Problem
A rectangular symbol is shown
instead of numbers on the
Temperature Display.
The compressor operates con-
tinually.
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows on the floor.
appears on the display.
The temperature in the appli-
ance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
Temperature sensor prob-
lem.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The QuickFreeze is switched
on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Solution
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible).
Refer to "Operation".
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze ".
Refer to "Closing the door".
The compressor starts after a pe-
riod of time.
Attach the melting water outlet to
the evaporative tray.
Keep the pressed for approxi-
mately 10 seconds until a long
sound is heard and display shuts
off for a short time.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance.
19