Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The control panel
1. "Function" key: Use this key to select the re-
quired function. The function selected is shown
by the lights numbered 4. You can select setting
the power level (Power), the temperature (Temp)
and the time (Timer).
2. "ON/OFF" key: Use this key to switch the appli-
ance on or to interrupt or reset the timer. When
you switch the appliance on, the most recently
selected function will light up and the display will
EN
go on. The red light next to the "ON/OF" key will
go on as soon as the appliance is at mains volt-
age and thus will not go off when you press the
"ON/OFF" key.
Operation
• Insert the plug in the wall socket; the red light
next to the "ON/OFF" key will now go on.
• Set the pan of your choice on the cooking sur-
face, bearing the above mentioned instructions
in mind.
• ATTENTION! Make sure that the pans are cov-
ering the indicated zones at all times during use
in order to prevent the appliance from getting
damaged.
• ATTENTION! Do not leave your pan on the appli-
ance while empty as this may lead to damage to
your pans.
• Switch the appliance on by pressing the "ON/
OFF" key. If your pan is suitable for induction and
has a bottom diameter of 12 cm, at minimum, the
appliance will go into operation. You will recog-
nize this from the fact that the fan will go on and
the display will show a power leve of "5".
6
4
Power
1
Function
Temp
Timer
2
5
3
3. "Arrow" keys: Use these keys for programming
the power level, temperature or timer. The up
arrow increases the setting value and the down
arrow reduces the setting value.
4. These lights indicate what mode you have select-
ed by means of the "Function" key.
5. You can read the set value on this display. These
are steps 1 through 10 for power level control,
from 60°C to 240°C for temperature control and
from 0 to 180 minutes for timer settings.
• ATTENTION! If the appliance beeps after being
switched on, the pan you are using is not suitable
for induction or the appliance is defective. In case
of any doubt, always contact the supplier of your
pan!
• Once the appliance is operating and the display
indicates power leve "5", you can program the
appliance in one of the following two ways:
- Power level: You can control the performance of
the appliance, just as for a gas stove, via power
level 1 through 10. Set the appliance to the de-
fault level "5".
- Temperature control: you can set the tem-
perature between 60°C and 240°C in 20°C in-
crements. Default setting for the appliance is
200°C. ATTENTION! The set temperature is that
of the glass plate and not the temperature in
the pan!
Advertenties
Inhoudsopgave
