Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CONTROL PANEL
LO50
LO70 & LO120
You switch the device on and off with the ON/OFF button.
Every time you press the buttons 'humidity up or 'humidity down, you set the desired
air humidity level1% higher or lower. If you depress the button for longer than 1.5
seconds, the set humidity will increase/decrease at a rate of 5 points per second.
If you press the memory button, the memory light will come on to show that the
memory is working. The memory will retain the settings, even if there is a power
outage or the plug is removed from the socket. Pressing this button again will switch
the function off. This means that the settings will be retained if you turn the device
ON or OFF with the appropriate button but will be forgotten if you remove the plug
from the socket.
STARTING AND OPERATING
Check that the socket, to which you are connecting the dehumidifier, provides the
voltage as indicated on the specification plate: 220/240V-50Hz.
L070 and LO120: Check that the drainage hose is correctly connected and is able to
drain properly into the appropriate waste outlet.
Insert the plug into the socket; the device will beep.
Press the ON/OFF button. The ON light will come on and the display will show the
factory setting for humidity: 60%.
After three seconds, the display will show the actual air humidity; this will remain on
the display while the device is on.
Press on the 'humidity up or 'humidity down button in order to set the desired level. If
the set humidity is over 3% lower than the actual humidity level, the device will start
to work and continue until the actual level is 3% lower than the set level. The device
will then switch off.
All manuals and user guides at all-guides.com
17
1.
Humidity display
2.
ON light
3.
Defrosting light
4.
Memory light
5.
Memory button
'Humidity up button
6.
'Humidity down button
7.
8.
ON/OFF button
'Water reservoir full' light
9.
(only L050)
Advertenties
Inhoudsopgave
