Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
30
www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze function is
switched on.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
pingMode function is
switched on.
The appliance is in dem-
onstration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The FastFreeze function is
switched on.
Solution
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FastFreeze
or ShoppingMode function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
