Troubleshooting - Amica KMI Series Gebruikershandleiding
Verberg thumbnails
Zie ook voor KMI Series:
- Gebruikershandleiding (68 pagina's) ,
- Gebruikershandleiding (56 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
TROUBLESHOOTING
In the event of any fault:
● turn off the appliance
● disconnect the power supply
● have the appliance repaired
● based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair
to customer service.
PROBLEM
1.The appliance does not
work
2.Sensor fields do not re-
spond when touched
3.The appliance does not
respond and emits and
extended beep
4.The appliance switches
itself off
5.A single cooking zone
switches off and residual
heat indicator "H" is shown.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
- no power
- appliance is not turned on
- sensor field touched
too briefly (less than one
second)
- multiple sensors touched
at the same time
- improper use (wrong sen-
sor fields touched or sen-
sors touched too briefly)
- sensor fields covered or
dirty
- no sensor field is touched
for 10 seconds of activating
the appliance
- sensor fields covered or
dirty
- timer
- sensor fields covered or
dirty
- electronic components
overheated
-check the fuse, replace if
blown
- Turn on
- touch the sensor field
longer
- always touch only one
sensor field (except when
a cooking zone is switched
off)
- reconnect the hob
- uncover or clean the sen-
sor fields
- Switch on the appliance
and set heat setting without
delay
- uncover or clean the sen-
sor fields
- turn on the cooking zone
again
- uncover or clean the sen-
sor fields
36
REMEDY
Advertenties
Hoofdstukken
