Amica KMI Series Gebruikershandleiding pagina 37
Verberg thumbnails
Zie ook voor KMI Series:
- Gebruikershandleiding (68 pagina's) ,
- Gebruikershandleiding (56 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
TROUBLESHOOTING
PROBLEM
6. Residual heat indicator is
extinguished even though
the cooking zones are hot.
7.Hob cooking surface is
cracked.
8.When the problem is still
not remedied.
9. Induction hob makes
buzzing sound.
10. Induction hob makes
hissing and whistling sounds.
11. The hob does not work.
The cooking zones will not
operate.
12. E2 symbol displayed
13. Er03 symbol
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
- a power outage or the
appliance has been discon-
nected.
Danger! Immediately unplug the appliance or
switch off the main circuit breaker. Refer the repair
to the nearest service centre.
Immediately unplug the appliance or switch off the main
circuit breaker (fuse). Refer the repair to the nearest ser-
vice centre.
Important!
You are responsible for operating the appliance correctly
and maintaining its good condition. If you call service as
a result of operating the appliance incorrectly you will be
responsible for the costs incurred even under warranty.
The manufacturer shall not be held liable for damage
caused by failure to follow this manual.
This is normal. Cooling fan is operating to cool down internal
electronics.
This is normal. When using several cooking zones at full
power, the hob makes hissing and whistling sounds due to
the frequencies used to power the coils.
Disturbances in the electri-
cal mains.
Induction coil overheated
Sensor fields covered by
more than 10 seconds, the
appliance switches itself off.
- residual heat indicator will
be shown again the next
time the appliance is turned
on and off again.
- reset the appliance,
unplug it for a few minutes
(disconnect the fuse).
- insufficient cooling,
- verify if the induction hob is
built in according to instruc-
tions.
- check if cookware complies
with requirements listed on
page 16.
Clean the touch control panel
surface and remove items
placed on sensor fields.
37
REMEDY
Advertenties
Hoofdstukken
