Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Chapter 1, INSTALLATION
1. Introduction
This chapter contains all the relevant information,
specifically:
• Installation specifications
• List of installation tools
• Basic requirements for the installation of the fuel
tank
• Instructions for the installation of the Laser System
The heater can be installed at any location, on condi-
tion that there is full compliance with electrical, fuel
and emission regulations.
Before you start installing the heating system (inclu-
ding electrical wiring and fuel supply equipment),
check the local building and fire safety regulations. The
requirements stipulated in these regulations must be
respected in order to guarantee a legally approved
installation and correct operation.
The heater was designed to be used to a
maximum altitude of 1000m above sea level.
Contact your dealer for the necessary
adjustments if you wish to use it at a higher
altitude.
2. Moving the heater
In addition to the space required for the heater, extra
room must be kept free for air circulation. The Laser
System can be placed on any type of flooring and oper-
ate safely, unless fuel or fire safety regulations specify
otherwise. Check the gaps in the manner stipulated in
the instructions in the manual.
All manuals and user guides at all-guides.com
Recommended tool kit
1. Crosshead screwdriver
2. Steel tape measure
3. Felt-tip pen or pencil
4. Cement for exterior use
5. Electric drill (clockwise and anti-clockwise
6. Hole cutting saw, jig saw or other tools suitable for
7. Long drill
8. Standard screwdrivers
9. Adjustable spanners (various sizes)
10. Copper tube cutter
11. Reamer
12. Volt, Ohmmeter
13. Spirit level
14. Plumber's tape for tube screw thread
15. Small range of self-tapping screws
16. Range of pliers (pin tongs, needle nose pliers,
17. Insulated screwdriver
18. Protective material for your floor
19. Container for fuel exhaust pipe
3. The electrical supply system
The electrical system must be protected from overloads
by an at least 5-Ampere fuse or contact breaker.
4. Fuel tank
Heater fuel (exclusively water-free, pure paraffin oil) in
200/1000 litre storage tanks located outside. If large
tanks are used, a pressure regulator with a max. of 2.5
PSI (± 0.17 bar) must be fitted at the inlet on the
heater. This must be carried out in strict adherence to
all local standards and/or building regulations.
recommended)
sawing a hole of 70~80 mm for the exhaust pipe
cutting pliers, locking pliers)
Some installations (such as for use in mobile
homes) must be fitted with a permanent
connection to the household power circuits.
This must be done by a recognised
electrician.
28
Advertenties
Inhoudsopgave
