Operation In Case Of Emergency - Amica SHI Series Gebruikershandleiding
Verberg thumbnails
Zie ook voor SHI Series:
- Gebruikershandleiding (72 pagina's) ,
- Gebruikershandleiding (72 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION IN CASE OF EMERGENCY
In the event of an emergency, you should:
switch off all working units of the cooker
disconnect the mains plug
call the service centre
some minor faults can be fixed by referring to the instructions given in the table
below. Before calling the customer support centre or the service centre check the
following points that are presented in the table.
PROBLEM
1.The appliance does not
work
2.Sensor fields do not re-
spond when touched
3.The oven lighting does
not work.
4. A single cooking zone
switches off and residual
heat indicator „H" is shown.
4.The appliance does not
respond and emits and
extended beep
5.The appliance switches
itself off
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
- no power
- appliance is not turned on
- The bulb is loose or dama-
ged.
- limited cook time
- improper use (wrong
sensor fields touched or
sensors touched too briefly)
- sensor fields covered or
dirty
- no sensor field is touched
for 10 seconds of activating
the appliance
- sensor fields covered or
dirty
-check the fuse, replace if
blown
- turn on the appliance
- Tighten up or replace the
blown bulb (see 'Cleaning
and Maintenance').
- switch on the cooking zone
again
- reconnect the hob
- uncover or clean the sen-
sor fields
- switch on the appliance
and set heat setting without
delay
- uncover or clean the sen-
sor fields
36
REMEDY
Advertenties
Hoofdstukken
Inhoudsopgave
