Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WARNING: Before taking any in-circuit resistance measurement, remove power from the circuit being tested and
discharge all the capacitors.
3.4. Resistance and Continuity Measurement23.4. Resistance and Continuity Measurement
Set the rotary switch at Ω
a.
b.
Insert the test leads into the input jack.
c.
Connect the test prods of the test leads to the two ends of the resistor or circuit to be measured.
d.
Read the measured value from the LCD display.
If the resistance is lower than 40 Ω, a beeping sound shall be heard.
e.
3.5. Relative Reading Measurements23.5. Relative Reading Measurements
The zero button also can be used to make a relative measurement. Once the button is pushed, the current reading is set to
zero and a zero symbol shall be displayed on LCD. All the subsequent measurement shall be displayed as a relative value with
respect to the value being zeroed. Press the zero button for 2 seconds to return to normal mode
3.6. Holding the LCD Reading
Press the HOLD button, then the reading shall be hold and kept on LCD.
All manuals and user guides at all-guides.com
34
Advertenties
Inhoudsopgave
