Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Symbols in this manual
This symbol indicates where cautionary or other information is found in the manual
+
Battery
1-2
Panel Description
Refer to Figure 1 and to the following numbered steps to familiarise yourself with the meter's front panel controls and connectors
1.
Transformer Jaw -This is used to pick up current signal. To measure DC/AC current, conductor must be enclosed by the jaw.
2.
Transformer Trigger - This is used to open the jaw.
3.
Function Selector Switch - This is used to select the function user desired, such as ACV, ACA, Ohm and Continuity.
4.
Frequency Selection Switch - At 50/60Hz position, only the low frequency signal is measured. At Wide position, signal from
40 - 1KHz is measured.
5.
Data Hold Button - Once this button is pushed, reading shall be held on the LCD. Press again to release it.
6.
Max/Min Hold Button - This button is used to enable the maximum or minimum value to be displayed and updated during
measurement. Press once, minimum value shall be displayed and updated. Press again, maximum value shall be displayed
and updated. Press again (the third push), clamp meter return to normal measurement mode. The Zero/Relative function will be
disabled if Max/Min function is enabled.
All manuals and user guides at all-guides.com
21
Advertenties
Inhoudsopgave
