Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
76
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
Use of combi detergent tablets
These products are detergents with a com-
bined cleaning, rinsing and salt functions.
Select and start a washing programme
Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Press the programme selection/cancel
button until the light corresponding to the
required washing programme comes on
(see 'Washing programmes' chart).
Close the appliance door, the pro-
gramme starts automatically.
All manuals and user guides at all-guides.com
They can also contain other different agents
depending on which kind of tablets you
choose ('3 in 1', '4 in 1', '5 in 1'etc.).
1. Check whether these detergents are suit-
2. Select the lowest setting for water hard-
If the drying results are not satisfactory
we recommend that you:
1. Fill up the rinse aid dispenser with rinse
2. Set the rinse aid dosage to position 2.
If you decide to turn back to the use of
standard detergent system we advise
that you:
1. Fill up the dispensers for salt and rinse aid
2. Adjust the water hardness setting to the
3. Adjust the water hardness setting ac-
4. Adjust the rinse aid dosage.
Setting and starting the programme with
delay start
1. Select a washing programme.
2. Press the delay start button. The corre-
3. Close the appliance door. The count-
4. Once the countdown has elapsed the
Cancel a delay start in progress
1. Open the appliance door.
able for your water hardness. See the
manufacturers instructions.
The refilling of the salt container and the
rinse aid dispenser are no longer neces-
sary.
ness and rinse aid dosage.
aid.
again.
highest setting and perform 1 normal
washing programme without loading any
dishes.
cording to the hardness of the water in
your area.
The start of the washing programme will
be delayed by 3 hours.
sponding indicator light comes on.
down starts automatically.
Opening the door will interrupt the
countdown. Once the door is closed the
countdown will continue from the point
at which it was interrupted.
washing programme will start automati-
cally.
Advertenties
Hoofdstukken
Inhoudsopgave
