Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
13.2 Protection mode
Status indicator
Status
Red steady/red flashing
Connection error. Please check all contacts.
■
Red on/alarm sound on
Reversed polarity: check if the clamps are connected the wrong way
around.
■
Short-circuit: Both cables are clamped together or clamped to the
same piece of conductive metal.
■
Red steady on
Reverse charging protection is triggered. Voltage of the connected
battery is >12.6 V.
■
The jump starter is not needed as the vehicle battery is enough to start
the vehicle.
Red flashing quickly
Over temperature: Clamp >65 (±5) ºC. Remove the clips until the starter
status indicator returns to normal (alternating red/green flashing).
Green flashing slowly
Quick start battery charge is too low, recharge it.
14 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage
the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.
15 Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU mar-
ket. This symbol indicates that this device should not be disposed of as unsorted municipal
waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separ-
ately from unsorted municipal waste. Spent batteries and accumulators, which are not en-
closed by the WEEE, as well as lamps that can be removed from the WEEE in a non-de-
structive manner, must be removed by end users from the WEEE in a non-destructive man-
ner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points set up by man-
ufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.
16 Technical data
16.1 General
Charging input (USB-C®)....................... 5 V/DC 2 A, 9 V/DC 2 A, 12 V/DC 1.5 A
DC output ............................................... 12 V/DC 10 A
Battery pack (rechargeable) ................... 14.8 V 59.2 Wh, Li-ion (non-removeable),16000 mAh
Battery pack (recharge time) .................. approx. 8 – 9 hours
Protection ............................................... Short circuit, overload, low voltage, over voltage, overcharge,
Over-discharge protection ...................... ≤13 V ±0.3 V
Over-temperature protection .................. >65 ºC ±5 ºC
Reverse charging protection................... ≥(12.6 V ±0.3 V)
Operating / storage conditions................ -20 to +40 °C, 20 – 85 % RH (non-condensing)
Dimensions (L x W x H).......................... 207 x 170 x 86 mm
Weight .................................................... 1.5 kg
16.2 Power bank
Charger output (USB-A) ......................... Output 1:
16.3 Jump starter
Vehicle on-board system........................ 12 V/DC
Start current (peak value)....................... 600 A (1200 A)
Jump starts............................................. approx. 15 (affected by factors such as ambient temperature,
Suitable engine types ............................. Gasoline (displacement ≤8.0 L), Diesel (displacement ≤6.0 L)
6
Fast charge 18 W
outer: ⌀2 mm, polarity (+)
inner: ⌀6.15 mm, polarity (-)
pin length: 1.95 mm
over temperature, reverse charging, reverse polarity
5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A
Fast charge 18 W
Output 2:
5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A
Fast charge 18 W
size, and mechanical condition of the engine)
16.4 Air compressor
Duty cycle............................................... 8 minutes ON, 5 minutes OFF
Air pressure ............................................ max. 10 bar (150 psi)
Motor ...................................................... zinc alloy
16.5 LED light
Light........................................................ White: 4000 K, 200 lm, 2 W
Light modes............................................ ON (white) → SOS (white) → ON (red) → Strobe (red)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*3164093_V3_0624_dh_mh_en 1442798475-2 I1/O3 en
Red: 80 lm, 2 W
Advertenties
Inhoudsopgave
