Advertenties
Beschikbare talen
Beschikbare talen
The enclosure
The refrigerator must be installed in a substantial enclo-
sure and must be level, the dimensions are shown in
TECHNICAL DATA.
The bottom of the enclosure must be horizontal and even
so that the refrigerator can be easily pushed into place.
It must be sturdy enough to carry the weight of the
refrigerator.
Make sure that there is a complete seal between the
front frame of the refrigerator and top, sides and
bottom of the enclosure. A length of sealing strip is
applied to the rear surface of the front frame for this
purpose, see fig.2.
Note: A wood strip must be in place across the upper
opening of the enclosure. The top frame of the refrigera-
tor will be anchored to the wood strip with screws. See
fig.7 b.
Push the refrigerator into the recess until the sealing
strip on the flange seals against the front of the recess,
so that the cooling unit is completely sealed off against
the interior of the caravan.
Note: Be careful not to damage the sealing strip when
the refrigerator is put in place.
FIG. 2
Securing the refrigerator
After the refrigerator is put in place, (insuring a combus-
tion seal at the front frame), the refrigerator is to be
secured in the enclosure with six screws. The screws
have to be installed in the following order:
A. Two screws installed through the front base, which
includes the lower front strip installation.
The refrigerator is provided with a lower front strip
(shipped as a loose part). The front strip is to be installed
after the refrigerator is set into the cut-out opening.
1.
Install the lower front strip by sliding it under the
bottom hinge plate, as shown in fig. 3. The hinge plate
can be on the right or left side depending on the door
swing.
FIG. 3
FIG. 4
2.
Once the lower front strip is slipped under the hinge,
the part is possible to swing into place as shown in
fig. 4.
3.
Secure the refrigerator and the lower front strip with
two screws:
One screw through the hinge and into the floor. The
second screw is installed on the opposite side
through the lower front strip. (Fig. 4).
B: Two screws installed in the top frame.
The top decoration panel must be removed from the
refrigerator before the screws can be installed. Open the
upper door and gently push the tabs out of the hole in
the hinge (both sides) with a flat blade screwdriver.
Carefully tilt the top decoration panel and lift up to
remove from top frame. See fig. 5.
Be careful not to damage the circuit board and wires.
23
Advertenties
Hoofdstukken
