Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The hotplates
Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Dual-circuit hotplate, hotplate
â
with extended cooking zone
When the hotplate is activated: the corresponding indicator lights up.
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
Twistpad with twist knob
The twistpad is the area in which you can select the hotplates
and set heat settings using the twist knob. The twist knob
automatically centres itself in the twistpad.
The twist knob is magnetic and is placed on the twistpad.
Tapping the twist knob where there is a marking activates the
relevant hotplate. Turning the twist knob sets the heat setting.
Removing the twist knob
You can remove the twist knob. This makes cleaning easier.
You can also remove the twist knob while the hotplate is in
operation. The wipe protection function is activated and
switches the hotplate off after 35 seconds.
:
Risk of fire!
If you place a metal object on the twistpad, the hob may
continue to heat up. For this reason, always switch off the hob
using the main switch.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
30
Activating and deactivating
Select the hotplate, touch the
Select hotplate, touch the
Touch the
ó
symbol. A signal sounds. The
symbol until the display above the
symbol.
ó
symbol, 2nd filament circuit is activated.
ó
symbol; the extended cooking zone is activated.
If
appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
œ
cooled sufficiently.
Storing the twist knob
The twist knob contains a strong magnet. Keep the twist knob
away from magnetic data carriers, such as video cassettes,
diskettes, credit cards or cards with magnetic strips. The data
these contain could otherwise be wiped. They can also cause
interference in television sets and monitors.
:
Hazard due to magnetism!
For wearers of electronic implants, e.g. pacemakers or insulin
pumps. Implants could be affected by magnetic fields. You
must therefore never carry the twist knob in a pocket in your
clothing. They must be kept at least 10 cm from pacemakers.
Note: The twist knob is magnetic. Metal particles which stick to
the underside can scratch the ceramic hob top. Always wipe
the twist knob thoroughly.
Operation without the twist knob
If you have misplaced the twist knob, you can operate the hob
without it:
Switch on the hob using the main switch.
1.
Within the next 5 seconds, simultaneously touch the L and
2.
symbols. A signal sounds.
Touch the
3.
desired hotplate lights up.
Set the desired heat setting using the L (-) and
4.
The hotplate is switched on.
Note: You can place the twist knob back on the twistpad at any
time.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 15 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.
. The display remains lit until the hotplate has
3
symbol repeatedly until the indicator for the
3
(+) symbol.
ó
Advertenties
Hoofdstukken
Inhoudsopgave
