Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN Setting of the end positions with setting switch
4.5.3. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top stop without release
When the movement is interrupted once, the system is in manual setupmode.
In manual setupmode, the lower end position must be set and stored first. Afterwards,
the upper end position can be set and stored.
Operation
E
6 s
E
E
3 s
E
E
3 s
Drive
Press the E button of the setting switch for 6 seconds.
The motor will switch to manual setting mode. Both limit
positions already set will be deleted.
Move the motor to the lower end position with the UP or
DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out
at the end of the end position setting.
Move in UP direction to up to 5 cm ahead of the upper limit
stop.
Press the E button for 3 seconds.
The end positions are now set and the rotation direction
assignment is correct. Perform a test run: The drive will move
against the upper limit stop now and will not relieve there!
30
Advertenties
Hoofdstukken
Inhoudsopgave
