Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
When operating air handling unit in the temperatures lower than 0 °C, it is
necessary to use glycol additionally or assure the reversible heating agent
temperature more than 25 °C.
It is important to maintain air heaters and coolers cleanliness; that is to
change filters installed in the air handling unit on time. If the air heater or
cooler gets dirty, to perform periodical cleaning.
Ductwork
The air flows in/out air handling unit through ductwork. We recommend using galvanized steel (Zn 275 gr/m
ductwork, to ensure easy cleaning and durability. It is necessary to use the ductwork system with low air flow rate
and small pressure drop to have necessary air volume and low sound level and save the energy. The appropriate
sound attenuators will reduce the noise level of the fans in the premises.
All ductwork should be insulated with 50–100 mm thickness insulation to avoid the condensation.
Note: temperature sensor B1 has to be mounted in the supply air duct under electric heater (see the functional
diagram in Control System Electrical Installation and Operation Manual). It is necessary to leave space in straight
air duct for sensor mounting and guarantee the space for maintenance and service work. Minimal space between
the unit and B1 sensor is the space of double air duct diameter.
Ductwork, steelwork and any other services should not be supported off
the unit.
In duct system, for units with electric air heater, use air closing damper
without spring return mechanism.
FINAL INSPECTION
After installation of the unit, a thorough inspection should be carried out. This should include inspecting the inside
of the unit and removing debris and tools, which may have been left behind by on site contractors. Replace any
panels, which may have been removed and close all access doors, ensuring that the door sealing gaskets have
not been damaged.
4. MAINTENANCE
It is recommended to carry out routine maintenance of the air handling unit REGO/RECU/OTK, 3–4 times per
year. REGO 1200P use the key to open the door. Do not release the door to swing freely, but open it slowly at a
90 degree angle. Be careful while opening, because clogged filters might fall out.
Besides preventive maintenance inspection, the following operations should be performed:
1. Rotary heat exchanger check. Inspection of the rotary heat exchanger is performed once per year. Free
rotation of the rotary heat exchanger, continuity of the rotating belt, absence of damages of the rotor drums
and the seal gasket are checked. It is necessary to check the stretch of belt. Free belt will slide and the
efficiency of rotary heat exchanger will fall down. To reach maximal efficiency, rotor must turn at least 8 times
per minute. Polluted heat exchanger will decrease efficiency. Clean heat exchanger with an air blast or wash
with tepid water. Check out water falling on the electric motor.
2. Plate heat exchanger check. Inspection and dedusting of the plate heat exchanger is performed once per
year (it is removed from the unit and blown with an air blast or washed with tepid water).
Note: plate heat exchanger may be replaced with summer cassette, when recuperation is needless.
3. Fans check (once per year). Polluted fans decrease efficiency.
Before performing any inspection work, check whether the unit is switched
off from the electric power supply.
Fans should be carefully cleaned with textile or soft brush. Do not use water. Do not break balance. Check if
direction of fan turns is right, because wrong direction of turns gives only 30 % rating. Check if fan freely ro-
tates and is not mechanically damaged, if impeller does not touch suction nozzles, fan does not spread noise,
the pressure tubes are connected to the nozzle (if it is required), mounting bolts are screwed.
The rubber couplings connecting the motor base and the unit should be visually inspected for signs of wear
and replaced as necessary.
12
UAB AMALVA we reserve the right to make changes without prior notice
)
2
Advertenties
Hoofdstukken
Inhoudsopgave
