Inhoudsopgave
Advertenties
32
!
If streaking occurs wipe
floor-tool blades clean (Fig.33).
On heavily soiled floors use a
'double scrub' technique.
First pre-scrub the floor with the
floor-tool in the raised position,
allow the chemicals time to
work then scrub the area a
second time with the floor-tool
lowered (Fig.34).
35
To operate, select forward, press the accelerator pedal.
Vacuum pick-up and water-flow will turn on if selected and the brush and
floor tool are in the lowered position, the machine will move forward.
Clean water is dispersed evenly via 'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor-tool (Fig.32).
Overlap each scrubbing path by 10cm to ensure an even clean.
After stopping the Vac motor will run for a further 10 seconds to collect any
water left in the vacuum hose.
Do not operate the machine on inclines that exceed 11%.
33
Use the maximum speed control knob and set desired traction
speed as required, depending on floor type and level of soiling
(Fig.35).
Keep speed setting within the white gradient on the dial for
optimum floor cleaning.
The grey gradient on the dial is for setting the transit speed.
Once the Max speed has been set using the control knob on the
control panel, fine adjustments can be made using the variable
control speed pedal located on the right side of the footplate.
Machine Operation
Maximum Speed Control
Cleaning
28
Machine in Use
34
Transit
!
Advertenties
Inhoudsopgave
