Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 www.aeg.com
Electronic adjustment
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time, De-
lay and Option until the indicators of
start to flash.
3. Press Program,
• The indicators of
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
,
and
and
go off.
A
A
+
-
• The indicator of
ues to flash.
• The display shows the current set-
ting of the water softener. E.g.
= level 5.
4. Press Program again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1.
Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
3.
Fill the salt container with dishwash-
er salt.
4.
Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
1.
Press the release button (D) to open
B
the lid (C).
2.
Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3.
Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4.
Close the lid. Make sure that the re-
lease button locks into position.
C
You can turn the selector of the
released quantity (B) between
D
position 1 (lowest quantity) and
position 4 (highest quantity).
contin-
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
