Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
Use the red adjustment lever to also switch between a wide
( ) and a narrow (
12. Selecting the Spray Setting
(Standard spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 6, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 7 A = vertical flat jet
Fig. 7 B = horizontal flat jet
Fig. 7 C = circular jet
13. Adjusting the Material Volume
(Wall Extra I-Spray spray attachment)
The volume of material can be set by turning the material volume control (Fig. 8, 1) in
steps from 1 (minimum) to 12 (maximum).
14. Adjusting the Material Volume
(Standard spray attachment)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
(Fig. 9)
lower material volume
higher material volume
28
) spray jet.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach surfaces
turn anti-clockwise (-)
turn clockwise (+)
W 590 Flexio
Advertenties
Hoofdstukken
Inhoudsopgave
