Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inspired by life
Reading the battery status
The battery indicator (S) on the control panels
shows the remaining battery capacity:
S
Battery indicator
Charging the batteries
1. Insert the battery charger plug into the
2. Insert the plug of the mains cord in a wall
X
3. Always fully complete the charging cycle of
Battery charger contact
Error codes
When there is a error message, the LED Bar will
flash.
Battery status
Indicator
All red and green
The batteries are full.
blocks are visible.
3 red blocks are
You can drive another
visible
2 4 miles (3 6 km)
(depending on the
type of battery and
other circumstances).
You should start
charging now.
1 block visible
Recharge the mobility
scooter as soon as
possible.
battery charger contact (X).
socket.
8 10 hours. The batteries are fully charged
when the green lamp is lit
Error message
Indicator
1 block flashes
The battery is empty or
connected incorrectly.
Check whether the
battery is connected
correctly. Then try to
charge the battery again.
Use
EN24
Error message
Indicator
2 blocks flash
The electrical connection
to the engine has been
interrupted. Have your
supplier check all engine
electrical contacts.
3 blocks flash
Short circuit between
engine and battery.
Contact your supplier.
4 blocks flash
The freewheel is
engaged or the brake
has been disengaged
manually. Check the
position of the freewheel
lever.
5 blocks flash
Not in use.
6 blocks flash
The brake has
intervened. For example
because the charger is
still connected or the
seat is not in the correct
driving position.
7 blocks flash
Error with regard to
the throttle. Switch off
the mobility scooter
and switch it back on.
Contact your supplier if
the problem persists.
8 blocks flash
Electronics error. Contact
your supplier.
9 blocks flash
The freewheel is
engaged or the brake
has been disengaged
manually. Check the
position of the freewheel
lever.
Use
EN25
Advertenties
Hoofdstukken
Inhoudsopgave
