Download Inhoudsopgave Inhoud Print deze pagina

Removing The Mower Deck - Toro HDX SD 2000 Series Gebruikershandleiding

Zitmaaier van 132 cm
Verberg thumbnails Zie ook voor HDX SD 2000 Series:
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Figure 82
1. Blades front to rear
2. Blade tip
8.
Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
9.
Place 2 blocks (see table below) under the rear
edge of the cutting deck skirt; 1 on each side of
the cutting deck
(Figure
10.
Set the height-of-cut lever to the 3 inch (76 mm)
position.
11.
Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
Figure 83
Bottom view
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
Deck Size
Block Height
All mower
7.3 cm (2.87 inches)
decks
12.
Carefully rotate the blades side to side
81).
All manuals and user guides at all-guidesbox.com
g229304
3. Measure from the tip of the
blade to the flat surface
here.
83).
g038090
2. Welds
Rake
4.8 to 6.4 mm (3/16 to 1/4
inch)
(Figure
13.
Loosen the locknuts
and ensure that the mower deck is sitting
securely on all 4 blocks.
14.
Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
15.
Tighten the 4 locknuts.
1. Locknuts
2. Deck-lift arm
16.
Ensure that the blocks fit snugly under the deck
skirt and that all attachment bolts are tight
17.
Continue leveling the deck by checking the
front-to-rear blade slope.
18.
Check the blades for levelness and repeat deck
leveling procedure if necessary.

Removing the Mower Deck

1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3.
Place the height-adjustment pin in the 7.6 cm (3
inch) cutting-height location.
4.
Remove the belt covers.
5.
Loosen the mower deck idler and remove the
mower belt; refer to
6.
Remove the bolts and nuts from the front of the
plate under the footrest.
7.
Remove and retain the bolts and nuts on both
sides of the machine
60
(Figure
84) on all 4 corners
Figure 84
3. Deck hanger
4. Chain
Belt Maintenance (page
(Figure
85).
g035851
49).

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

77292te

Inhoudsopgave