Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.2 Install the unit
Follow the steps below for mounting the unit.
1. Unpack the unit
Take the unit from the packaging at the place of the 2 cut-aways in the packaging to avoid damaging the glass.
2. Materials
Check if all materials have been supplied.
3. Cut-away for surface mounting and flush mounting
The cooking plate can be mounted both through surface mounting and flush mounting with respect to the table
top.
Conditions for the cut-away:
• Table tops are to be made from heat-resistant materials (100°C).
• The materials of the table top can expand when they come into contact with water. Veneer the cut-away or
coat it with a special type of glue for protection.
• Observe the instructions of the table top manufacturer.
a. Surface mounting
Make a cut-away in the table top in accordance with the drawing 3a.
b. Flush mounting
Make a cut-away and a milling edge in the table top in accordance with the drawing 3b.
c. Ventilation 1811 One Pro + d. Ventilation 1801 One Power
Provide a ventilation opening just below the worktop of 4mm over a width of min. 600mm for sufficient cooling of
the induction hob. Also provide sufficient air inlet under the appliance.
4. Install the insulation strip
Do not turn the device over completely to prevent damage to the glass or failure of the components of the extraction
tower.
Stick the insulation strip 2 mm from the outer edge at the rear side of the glass plate.
5. Install a bend for the exhaust duct
If the exhaust duct is mounted directly with a downward bend, first place the supplied bend on the unit. The
connection for the exhaust duct is on the rear of the unit. Make the connection airtight with aluminium tape.
6. Install the unit
Place the unit in the opening provided. Firmly hold the cooking plate on the left and the right sides. Slightly tilt it
and place the rear side into the openings. Then carefully lower the front side.
The duct can now be connected. For this follow the description in chapter 3.
3. INSTALL THE EXHAUST DUCT
3.1 Recirculation
In cases that do now allow for an exhaust duct to the outside, recirculation offers a solution. For this Novy offers an
exhaust box with Monoblock recirculation filter. The exhaust box is the ideal solution for making the unit suitable for
recirculation (drawing 7).
EXHAUST BOX
The exhaust box is connected to the exhaust dust coming from the unit. The Monoblock recirculation filter is installed
in the exhaust box. A choice can be made from the following exhaust box models (incl. Monoblock recirculation filter):
Typ
Model
7921400
Recirculation box H 98 with Monoblock filter WHITE
7922400
Recirculation box H 98 with Monoblock filter BLACK
7923400
Recirculation box H 98 with Monoblock filter STAINLESS STEEL LOOK
7931400
Recirculation box H 140 with Monoblock filter WHITE
7932400
Recirculation box H 140 with Monoblock filter BLACK
7933400
Recirculation box H 140 with Monoblock filter STAINLESS STEEL LOOK
Dimensions
Duct connection
(hxwxd) (mm)
98 x 818 x 290
222 x 89
140 x 820 x 292 222 x 89
EN 21
Advertenties
Hoofdstukken
Inhoudsopgave
