Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
Installation
Refer to the nearest Authorized Service
Agent for installation of the product. To
make the product ready for use, make sure
that the electricity and water drainage
system are appropriate before calling the
Authorized Service Agent. If they are not, call
a qualified technician and plumber to have
any necessary arrangements carried out.
Preparation of the product's
C
location as well as the electrical and
waste water installations is under
customer's responsibility.
Installation and electrical
B
connections of the product must
be carried out by the Authorized
Service Agent. Manufacturer shall
not be held liable for damages that
may arise from procedures carried
out by unauthorized persons.
Prior to installation, visually check
A
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
A
Let your dryer wait for 12 hours
before starting to use it.
3.1 Appropriate installation
location
•
Install the product on a stable and level
surface.
•
Dryer is heavy. Do not move it by
yourself.
•
Operate your product in a well ventilated,
dust-free environment.
•
Do not block the air ducts in front of and
under the product with materials such as
long pile rugs, wooden blocks and bands.
•
Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
•
Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure
that the rear wall of it does not touch
anywhere (tap, socket, etc.). Also
pay attention to select an installation
location which you will not be required to
Dryer / User Manual
change afterwards.
•
Place the product at least 1.5 cm away
from the edges of other furniture.
•
The rear surface of the tumble dryer
shall be placed against a wall
B
Do not place the product on the
power cable.
3.2 Removing the
transportation safety
assembly
A
Remove the transportation
safety assembly before using the
product for the first time.
1.
Open the loading door.
2.
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with XX XX.
3.
Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Make sure that no part of the
transportation safety assembly
remains inside the drum.
43 / EN
Advertenties
Inhoudsopgave
