Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
commeo commissioning/setting by radio
Note for settings under point 5.2.: The drive must be selected for these settings with a
transmitter in SELECT mode (status LED slowly flashes orange). After the setting has been
configured, the drive is still selected (see point 5.).
5.2.3. Manual setup mode WITHOUT relief
in operation: bottom position, top position
When the movement is interrupted once, the system signalises that it is in manual setup
mode.
Operation
6 s
or
3 s
or
3 s
Movement
Press the STOP button on the transmitter for 6 seconds.
The drive switches to manual setup mode. Both previ-
ously set end positions are deleted.
Move the drive to the lower end point using the UP or
DOWN button.
STOP
Press and hold the STOP button for 3 seconds. The
direction of rotation will be set correctly after the end
positions have been set.
Move the drive with the UP or DOWN button upwards
5 cm
to the required lower end limit. A correction is allowed.
STOP
Press and hold the STOP button for 3 seconds. The end
positions are now set and the direction of rotation is set
correctly. Perform a test run. The drive now only moves
between the set end positions.
Note: The transmitter may not have been programmed
yet. To programme a transmitter, see point 5.2.4.
51
EN
Advertenties
Hoofdstukken
Inhoudsopgave
