Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Setting the end positions
4. Setting the end positions
4.1. Delivery state
In the delivery state, no end positions or transmitters are programmed into the
SE Breeze-com!
In this state, the drive can only be operated in deadman mode. The safety functions and the
wind monitoring are deactivated by default and only become active after both end positions
have been set.
In the delivery state, the SE Breeze-com is set to semi-automatic mode. This is signalised by a
short up and down movement when the drive is connected to the mains power supply.
4.2. Setting options
The end position for a SELVE radio drive can be set with:
• the setting switch for radio drives (article no. 290109 or 291009) or with
• any wired switch (only in semi-automatic setup mode)
or with
• any commeo transmitter.
4.3. Mechanical requirements
When setting the drive in semi-automatic setup mode, a fixed upper stop must be fitted (e.g.
box awning). In the case of open awnings without an upper stop, the upper and lower end
positions are set as fixed points in manual setup mode.
There is no automatic setting of the lower end position with the SE Breeze-com. The lower
end position must always be approached or also set.
4.4. Selection table for settings
Setup mode/end positions in operation
Semi-automatic setup mode
bottom position, top stop WITH relief
Semi-automatic setup mode
bottom position, top stop WITHOUT relief
Manual setup mode
bottom position, top position, WITHOUT relief
Setting switches
4.5.1. (page 43)
4.5.2. (page 44)
4.5.3. (page 45)
41
commeo radio
5.2.1. (page 49)
5.2.2. (page 50)
5.2.3. (page 51)
EN
Advertenties
Hoofdstukken
Inhoudsopgave
