m
WARNING! Risk of injury!
Before switching on the product, make
u
sure that the line spool
touch any stones, scree, or other foreign
objects .
Switch on the product before you
u
approach the grass that is to be cut .
Do not overload the product during
u
operation .
Avoid contact with obstacles (stones,
u
walls, fences, etc .) . Otherwise the line
spool
wears out quickly .
[
16 ]
Avoid using the product in bad weather,
u
especially if there is a danger of
lightning .
Do not select a position for the auxiliary
u
handle
that is too close to the upper
10 ]
[
handle
. Otherwise you cannot control
2 ]
[
the product properly .
When working, hold the product so that
u
the protective cover
the trimming assembly .
Troubleshooting
Problem
Possible cause
The product does
The on/off switch
not start .
The motor is defective .
The product works
Internal loose contact .
with intermittent
The on/off switch
operation .
The product makes
The trimming assembly is dirty .
much vibration and
loud noise .
The motor is defective .
The trimming result
The line spool
is bad .
enough cutting line .
The cutting line is not led out of the
spool cover
does not
16 ]
[
protects you from
8 ]
[
is defective .
[
1 ]
is defective .
1 ]
[
does not have
16 ]
[
.
[
15 ]
Cutting grass
H
Cut the grass by swaying the product
o
sideways to the right and left .
Cut slowly and hold the product with the
o
cutting circle parallel to the ground when
cutting .
Cut tall grass by a series of levels from top
o
to bottom .
Action
Contact our customer service to have
the product repaired .
Clean the trimming assembly
(see "Cleaning") .
Contact our customer service to have
the product repaired .
Extend the cutting line if required
(see "Extending the cutting line") .
Replace the line spool
(see "Replacing the line spool") .
1 . Remove the spool cover
2 . Feed the cutting line through the
line outlet loop
3 . Reinstall the spool cover
16 ]
[
.
15 ]
[
to the outside .
15b ]
[
.
15 ]
[
GB/IE/NI
15