Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Switch the product off and disconnect it
from the mains if there are malfunctions .
Have the product checked by a qualified
professional and repaired, if necessary,
before you operate it again .
Residual risks
Even if properly operating and handling
the product, some residual risks will remain .
Due to its construction and build, the
product may present the following hazards:
–
Cuts;
–
Hearing loss if working without hearing
protection;
–
Damage caused to your health resulting
from hand/arm vibrations if the power
tool is used over a longer period of
time or if it is not properly used and
maintained .
NOTE
This product produces an electromagnetic
u
field during operation! This field may
under some circumstances interfere with
active or passive medical implants! To
reduce the risk of serious or fatal injury,
we recommend persons with medical
implants to consult their doctor and the
medical implant manufacturer before
operating this product!
˜ Before first use
˜ Unpacking the product
1 . Take the product out of the packaging and
remove all packaging materials and plastic
wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts
are in good condition, if any damage or
defect is detected, do not use the product,
but follow the procedure described in
chapter "Warranty" .
˜ Assembly
Centre piece (Fig. B)
1 . Place the centre piece
head
.
[
7 ]
2 . Place the handle section
piece
.
[
6 ]
3 . Fix the centre piece
head
and the handle section
7 ]
[
4 long cross-head screws
Protective cover (Fig. C)
1 . Place the protective cover
motor head
.
[
7 ]
2 . Fasten the protective cover
cross-head screws
Auxiliary handle (Fig. D)
1 . Unscrew and remove the pre-installed
nut
and bolt
12 ]
[
13 ]
[
handle
.
[
10 ]
2 . Pull the ends of the auxiliary handle
apart and slide them over the handle
unit
.
[
14 ]
3 . Screw on the auxiliary handle
bolt
and nut
[
13 ]
12 ]
[
˜ Operation
m
CAUTION! Risk of injury!
Do not operate the product without the
u
protective cover
8 ]
[
Wear suitable clothing as well as eye
u
and ear protection .
Prior to every use, check that the product
u
is fully functional .
Do not lock the on/off switch
u
place . After releasing the on/off switch,
the motor must switch off . Stop using the
product if the on/off switch is damaged .
NOTE
Observe local regulations concerning
u
noise protection .
onto the motor
[
6 ]
onto the centre
[
5 ]
to the motor
6 ]
[
with
5 ]
[
.
11a ]
[
onto the
8 ]
[
with 2 short
8 ]
[
.
[
11b ]
of the auxiliary
10 ]
[
with the
10 ]
[
.
.
in
1 ]
[
GB/IE/NI
13
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
