Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Before first use
˜ Accessories
To operate this product safely and correctly, the
following accessories, i .e . tools and accessory tools,
are necessary:
Suitable spray material
o
Suitable personal protective equipment
o
Spray material is available through your authorised
dealer . When buying always consider the technical
requirements of this product (see "Technical data") .
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer .
m
WARNING!
Do not use accessories not recommended
u
by Parkside . This may result in electric shock
or fire .
˜ Unpacking
1 . Open the packaging and remove the product
carefully .
2 . Remove the packaging material as well as the
packaging and transport bracing (if available) .
3 . Check that the delivery is complete .
4 . Check the product and accessory parts for
transport damage .
m
WARNING!
The product and the packaging materials are
u
not children's toys! Children must not play
with plastic bags, sheets and small parts!
There is a danger of choking and suffocation!
˜ Before use
˜ Checking viscosity
The product allows you to use spray material
o
with a viscosity of max . 70 DIN/sec .
Measure viscosity (Fig . H):
o
–
Fill the measuring cup
spray material .
to the brim with
20 ]
[
–
Let the liquid run out of the measuring
cup
.
[
20 ]
–
Measure the seconds until the spray material
stops running out of the measuring cup
The measurement result is the DIN/sec value .
If you measure more than 70 DIN/sec:
o
Dilute the spray material gradually with a
suitable diluent until you measure a value
≤ 70 DIN/sec .
NOTE
Only use thinners that are suitable for the
u
respective spray material . If you use the
wrong thinner, lumps will form and clog the
product .
Never mix synthetic resin paints with
u
nitro thinner!
Read the manufacturer's instructions for the
u
respective spray material to find out about the
appropriate thinners .
Do not spray granular/body‑containing
u
material .
˜ Preparing the spraying area
Cover the area around the spraying surface .
o
Any uncovered surfaces in the vicinity may
otherwise become contaminated .
Dry and clean the spraying surface .
o
If you are painting surfaces made of wood,
o
metal or plastic: Roughen the spraying surface,
e .g . by sanding the spraying surface with
sandpaper .
˜ Assembly
m
WARNING!
Switch off the product and disconnect
it from the mains before replacing
attachments .
˜ Removing the spray unit
1 . Open the lock
:
24 ]
[
–
Hold the motor unit
–
With the other hand, turn the spray unit
firmly in a counter‑clockwise direction until the
spray unit disengages from the lock (Fig . E) .
.
20 ]
[
by the handle
.
14 ]
[
23 ]
[
4 ]
[
GB/IE/NI
11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
