Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If the connection terminals are connected to the battery and the device is connected to the mains,
the digital display
will show the "Connected" display. Once the charging mode has been selected
6
with the charge start button
the "Charged" display lights up. If the digital display "0.0" is continually lit before the battery is
completely charged, there is a defect.
In this case, check again if the connection terminals
„
whether the correct battery type has been chosen. If the display continually shows "0.0", there may
be a defect in the battery.
Reactivation function / reconditioning:
If a voltage between 8.5 V and 10.5 V is detected in the connected battery, the device will automatically
start a reconditioning process in order to reactivate the battery. If a voltage between 8.5 V and 10.5 V is
measured after the reconditioning process, then "Err" will be shown on the digital display. In this case,
the battery is faulty and must be replaced.
PLEASE NOTE: This function is only available for 12 V batteries.
Digital Display button
Enables the switch between the digital display of the voltage and charging progress in percent
(Battery %). Use this button to switch between the following displays:
Battery %: shows the charging progress of the connected battery in percent.
„
Voltage: shows the voltage of the connected battery.
„
Alternator % check: Output power of the alternator in percent.
„
Battery Type button
Use this button to set the battery type to be charged. You can choose between different battery types.
The battery type must be correctly set before starting the charging process:
12 V Regular: These batteries (lead-acid batteries) are usually used in cars, trucks and motorcycles.
„
They have venting caps and are often marked as "low-maintenance" or "no maintenance". This battery
type is meant for transferring energy quickly (e.g. starting an engine). "Regular" batteries should not be
used for "Deep-Cycle/Marine" applications.
12 V Deep-Cycle: These batteries are usually also marked as "Deep-Cycle" or "Marine".
„
Batteries of this type are usually larger than other battery types. This supplies less short-term energy,
but a longer-term energy transmission. These batteries can withstand a large number of discharge
cycles.
12 V AGM/Gel: The AGM battery types are usually good deep-cycle batteries. They have the best
„
"service life" if they are recharged before they have been discharged by more than 50%.
At complete discharge they can withstand about 300 charge cycles. The battery type GEL is similar to
the battery type AGM. The voltage at recharging is lower than in other lead-acid batteries.
If you use the wrong car battery charger for a gel battery, a reduced output or shorter service life can
be expected.
6 V Regular: Choose this mode for commercial rechargeable 6 V batteries. Charge current 2A
„
PLEASE NOTE: If you connect a 12 V car battery to a car battery charger and the car battery
charger automatically detects it as a 6 V battery, it can be assumed that this 12 V car battery is faulty
and needs to be replaced.
Charge Start button
Use this button to switch between the following options and start the charging process:
Fast Charge: fast charging
„
12
GB/IE/NI
, the "Charging" display will light up. When charging is complete,
3
:
1
:
2
:
3
,
are correctly attached to the battery and
4
5
Advertenties
Hoofdstukken
Inhoudsopgave
