Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The following factory values will be effective:
Settings
Operation
Comfort setting temperature
Eco setting temperature
Boost duration
Keypad lock
User settings
Backlighting
Frost protection temperature
Maximal Boost duration
Maximum ambient temperature
for the automatic stop of the
Boost
Installer settings
Automatic open window
detection
Occupancy detection
PIN code protection
Value of the PIN code
Expert settings
Sensor adjustment
Internal temperature monitoring 65°C
Hysteresis adjustement
To exit the Expert settings, press
MAINTENANCE AND
CLEANING OF THE DUST
FILTER
Before any maintenance work, switch off the device by pressing the but-
ton (switch).
The device can be cleaned with a damp cloth; never use abrasives or
solvents.
• Maintenance and cleaning of the dust filter
The blower is equipped with a removable dust filter which retains
impurities from the air aspirated into the room.
When the filter is saturated, the dust accumulation may cause its stop.
Factory settings
19°C
15°C
60 min.
Disabled
L3
7°C
60 min.
25°C
Enabled
Enabled
Disabled
0000
0.0
1.0°C
3 times.
To clean the filter, proceed in the following order:
FILT
In Boost mode, the writing
Before any action of filter removal, switch off the device by pressing the
button located under the blower.
1- Press the filter strip by the right or the left side then take it out from
its slot.
2- Use a vacuum cleaner to eliminate the dust deposited on the filter.
If the filter is very dirty, wash it under the water tap with a damp
sponge. After washing the filter, let it dry.
Important : it is recommended to clean the filter at least once a mon-
FILT
th unless the writing
3- Once cleaned and dried, replace the filter in its slot by inserting it
into the runners.
EN
appears on the display.
appears on the display prematurely.
M16MI325 A03_06/18
19
Advertenties
Hoofdstukken
Inhoudsopgave
