Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PIN code initialisation
By default, the PIN code is not enabled. The setting access is available in
Standby mode only.
1- By default registered PIN code is 0000.
Press
or
to select 0. It is blinking. Save by pressing
2- For others numbers, select 0 by press
When 0000 appears, press on
The PIN code is initialized, the next setting automaticaly appears:
PIN Code activation.
Activation/deactivation of the PIN Code
OFF
1-
appears on the display.
Press
or
to enable PIN code.
ON
appears on the display.
ON
= PIN code enabled
OFF
= PIN code disabled
2- Press
to save and return to the home installer settings display.
The PIN code is enabled. Any modification of reserved settings listed in
"Overview" is now impossible.
1
2
.
again to save and exit.
Customizing the PIN code
If you have just activated the PIN code, follow the stages described be-
low.
Alternatively, you must copy the steps 1 and 2 of the initialisation pro-
cess as well as the steps 1 and 2 of the activation process before perso-
.
nalising the PIN code.
Please remember that the personalisation of the PIN code can only be
set once the initialisation and activation of the PIN code has been com-
pleted.
On
1- When
appears, press
2- The 0000 code appears and the first number blinks. Press
to select the first desired number then press
exit. Repeat this operation for remaining 3 numbers.
3- Press
to confirm. The new code is now saved.
4- Press again on
to exit setting PIN code mode and go back to the
home display of the installer settings.
To exit the Installer settings, press
RESTORING FACTORY SETTINGS
If the PIN code protection is disabled, the user and installer settings are
re-initialized:
1- From the PIN code setting, press
display.
EN
for at least 5 seconds.
5 sec.
to save and
1
2
twice.
rest
.
appears briefly on the
M16MI325 A03_06/18
or
15
Advertenties
Hoofdstukken
Inhoudsopgave
