Inhoudsopgave
Advertenties
Tempura Quadra | Heizsystem | Warmtestraler | Heating system | Système de chauffage | weinor GmbH & Co. KG | 121070-0000w | v9 | 2024-06-17
General
en
Please read these instructions and observe their contents and
warnings before assemble the equipment!
Intended use
The Tempura Quadra is an electric radiant heater which can only be used
as such. The Tempura Quadra Universal design option is intended for wall
mounting. The Tempura Quadra Opal design option is intended exclu-
sively installation on a weinor Opal Design II awning (without Valance).
Misuse can lead to hazards and damage and is not permissible. Prohibited
changes to the product will result in voiding of the guarantee claims.
The Tempura Quadra is not to be used by people (children included)
with limited physical, sensory or mental abilities or who lack the required
experience and/or knowledge unless they are accompanied by someone
responsible for their safety or have been properly instructed in the use of
the Tempura Quadra. The Tempura Quadra does not feature an appliance
for the control of the room temperature. There the Tempura Quadra must
not be used in small rooms that are occupied by people who cannot leave
the room on their own, unless they are constantly monitored!
CE mark
weinor GmbH & Co. KG declares that the product is in compliance with
the basic requirements and relevant provisions of the EN
standards. This product meets the requirements of the guidelines and
standards listed in the EC Declaration of Conformity.
Safety symbols
Warning! Risk of electric shock!
Careful! Personal injury!
Caution! Product and property damage!
Safety instructions
Warning!
Risk of electric shock!
• Follow the warning instructions for the prevention of electrical shock!
• Electrical installation or repairs may only be carried out by an authorised
electrically skilled person according to VDE 100!
• Separate the electrical connections from the mains during the
installation!
• Only connect electrical termination to mains system with all-pole
disconnecting device and with min. 3 mm contact opening width!
• Only connect the construction if indications on product relating to
voltage, frequency and output match those of the power source!
• Always disconnect the heater from the mains for disassembly or when
replacing a tube (infrared lamp)!
• Before cleaning, unplug the all-pole disconnector from the mains.
• Do not let any liquids get into the heater!
• It is not permitted to make any changes to the temperature-resistant
silicon lead, which is screwed onto the device!
• If the power cord of the device has been damaged, it must be replaced
by the manufacturer or the customer service or a similar qualified
person, in order to avoid hazards!
Technische Änderungen vorbehalten | Technische wijzigingen voorbehouden | We reserve the right to make technical changes | Sous réserve de modifications techniques
Caution!
Danger of personal injury or burns!
• Note that the heater's installation height must be at least
1.80 m*!
• Pay attention to any children and vulnerable people present who cannot
correctly assess the dangers of heat and hot product components!
• Supervise any children present to make sure that they do not play with
the device and keep unsupervised children (younger than 3 years old)
away!
• Children between the ages of 3 and 8 may only switch the device on
and off if they are supervised, or if they have been instructed regarding
the safe use of the device and have understood the resulting dangers
(provided that the device has been placed and installed in its correct
operating position)!
• Children between the ages of 3 and 8 must not plug the plug connec-
tor into the power socket, control the device, clean the device and/or
perform the maintenance** !
• Caution! Acute risk of burns! Do not touch the heater housing as well
as safety guard during operation and immediately after operation!
• Caution! Risk of fire and deflagration! Do not use any flammable
cleaning agents (e.g. petrol, white spirit, etc.)!
• Caution! Looking at the infrared lamp for too long may lead to eye
damage! Avoid looking at the lamps when they are switched on!
Caution! Product and/or property damage may
result from improper installation, operation and
maintenance!
• Use suitable installation and fitting materials (plugs, glue, etc.) corres-
Danger level III
ponding to onsite conditions and loads to ensure
proper mounting!
Danger level II
• Do not place and mount the heater underneath sockets,
junction boxes etc.
Danger level I
• Always mount the switch for turning the heater on and off in sight of
the heater or label it clearly.
• Do not mount the heater in the vicinity of flammable fabrics.
• Do not mount the heater on awnings **** with Valance or Valance Plus
*** !
• Make sure that all the materials around the heater have the required
properties (as confirmed by the manufacturer's
information or measurements)!
• Never directly touch the infrared lamp. This shortens the lamp's ope-
rating life. Wipe the lamp with a soft cloth to completely remove any
greasy residue if it has come into contact with skin!
• Never leave the heater unattended during operation!
Other information
• Wood panelling on the wall and roof may become darker
in colour due to heat from the device, even with proper
installation.
• Keep this document in a place where it is available at all times even after
completing the installation!
*)
If mounted on an awning, the awning headroom determines the heater's installati-
on height.
The heater's installation height must be at least 1.80 m*!
**)
With maintenance carried out by user.
***) Exception: A control ensures that the awning is always extended first and then the
Valance Plus and that the Valance Plus is always retracted first before the awning. In
this way safety clearances are always adhered to.
****) The fitting of Tempura Quadra to an awning refers to the weinor Opal Design II/LED.
7
Advertenties
Hoofdstukken
Inhoudsopgave
