Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
24
Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Replacing the lamp
CAUTION! Disconnect the plug
from the mains socket.
1. Pull the left side of the lamp cover with
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. The
maximum power is shown on the light
bulb cover.
3. Install the lamp cover.
Solution
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
1
2
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
