4. Use of the appliance
Your unit has only one control for regulating the temperature in the compartment. The
temperature control is located on the upper right hand side of the compartment. The first
time you turn the unit on, set the temperature control to "6". The range of the temperature
control is from position "OFF" to "6". After 24 to 48 hours, adjust the temperature control to
the setting that best suits your needs. The setting of "4" should be appropriate for home or
office use. To turn the appliance off, turn the temperature control to "OFF".
NOTE: Turning the temperature control to "OFF" position stops the cooling cycle but does not
shut off the power to the unit. If the unit is unplugged, has lost power, or is turned off, you
must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time
delay, the unit will not start.
4.1 Prolonged off periods
If the refrigerator is not used for a long period of time, proceed as follows:
Disconnect the refrigerator from the main supply by removing the plug from the wall socket.
Clean and dry the inside as instructed under the heading of cleaning the refrigerator. Leave
the door open to prevent any unpleasant smells from building up while the refrigerator is not
in use.
4.2 Replacing the lamp
1 Pull off the plug, cut off the power supply.
2 According to figure 1 direction, take down the shade
3 According to figure 2 direction of rotation can remove the light bulb, and then turn to the
opposite direction of the new light bulb.
4 Put back the cover and connect power supply.
NOTE: Can not use the power greater than 15W.
EN - 21