Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Before using your refrigerator
Remove the exterior and interior packing. Before connecting the refrigerator to the power
source, let it stand upright for approximately 2 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation. Check to be sure
you have all of the following parts:
•
3 Bottle holders
•
2 Glass shelves
•
1 Crisper
•
1 Instruction manual
Clean the interior surface with lukewarm water using a soft cloth.
3.1 Space requirements
WARNING: Keep flammable materials and vapors, such as gasoline, away from refrigerator
Failure to do so can result in death, explosion, fire or burns.
To ensure proper ventilation for your refrigerator, allow for 200mm space on each side
between walls 200mm space between back of your refrigerator and the wall, and 300mm
space between counter top and the roof or ceiling. If you are installing your refrigerator next
to a fixed wall, leave sufficient space on the hinge side to allow for the door to swing open
Never install your refrigerator near heat source and direct sun shines.
3.2 Electrical requirement
WARNING:
Failure to follow these instructions can result in death, fire or electrical shock. Before you
move your refrigerator into its final location, it is important to make sure you have the proper
electrical connection. Recommended Earthing Method: A 220~240 Volt/50 Hz AC only 10
ampere fused and properly earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided. Use a receptacle which cannot be
turned off with a switch or pull chain. Do not use an extension cord.
DO NOT REMOVE GROUND PRONG
DO NOT USE AN ADAPTOR
DO NOT USE EXTENSION CORD
EN - 19
Advertenties
Inhoudsopgave
Probleemoplossen
