Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problems
The device does not
heat
The device does not
follow the programming
instructions
The device's surface is
very hot
The heating device
heats constantly
Odour when first swit-
ched on
- The guarantee period is two years from the date of installation or purchase and may not exceed
30 months from the date of manufacture in the absence of a receipt.
-The guarantee covers the replacement and supply of components recognised as being defective,
excluding any damages or interest.
- The user is responsible for any labour or transport costs.
- The guarantee does not cover any damage arising from improper installation, abnormal use or non-
observance of the requirements of the said instructions for installation and use .
- The stipulations of the present guarantee conditions do not exclude any of the purchaser's legal
rights of guarantee against faults or hidden defects, which are applicable in all cases under the sti-
pulations of Articles 1641 of the Civil Code.
- Present this certificate to your distributor or installer only in the event of a claim, together with
your purchase invoice.
TYPE OF DEVICE*:
SERIAL NUMBER*:
CUSTOMER'S NAME AND ADDRESS: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
* This information can be found on the information plate situated on the left-hand side of the device.
ATLANTIC INTERNATIONAL
Tel: (33) 146836000
Fax: (33) 146836001
I
N CASE OF PROBLEM
- Check that the programming unit is in Comfort mode.
- Check that the premise circuit breakers are triggered or that the load
shedder (if you have one) has not interrupted the device's power supply.
- Check the air temperature in the room.
- Ensure that you use the programming unit correctly (refer to the instruc-
tions manual), that the programmer is correctly lodged in its housing and
that it is operating normally (check the condition of the batteries).
It is normal for the device to be hot when it is operating. The maximum
surface temperature is restricted in accordance with the NF Electricité
Performance standard. However, if you think that your device is always
too hot, check that the output is suitable for the area of your room (we
recommend 100W / m
which would disrupt its setting.
- Check that the device is not located in a draft or that the temperature
setting has not been set high.
- When it is first switched on, the device may give off a slight odour. This
is not the result of any fault in the device and the odour will dissipate
after a few minutes. If necessary, air the room until the odour dissipates.
W
ARRANTY CONDITIONS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Check
) and that the device is not placed in a draught,
2
18
Advertenties
Inhoudsopgave
