Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Heating indicator V1
This shows when the resistance heating elements are supplying heat. It goes out when the tempera-
ture is too high.
Stopping the heating.
To set the heating to the OFF position, position the cursor A
on
.
Locking the controls
Knobs B and C can be locked in position or its range restricted
to prevent inappropriate use (by children, etc..).
1) Unhook the device from the wall bracket.
2) Detach pins P from their supports on the rear of the
thermostat box.
3) Select position N to lock the knob or position L to res-
trict its adjustment range.
Select one of the positions M to lock the cursor in the
desired mode.
Programming mode
The device is fitted with a thermostat that can be controlled via the control wire. It recognises the
following commands:
- COMFORT
- ECO
- FROST PROTECTION
- STOP
To activate Programming mode, set cursor A to
The heater will then respond to a programming device for selection of the Comfort and Eco tempe-
rature periods by connecting the control wire to a programming unit or another device fitted with
a time clock to save on energy.
NB: If no commands are received via the control wire, the device operates in Comfort mode.The
frost-free and power interruption commands are prioritised over the Eco and Comfort modes.
When switching from Comfort to Eco mode, the switchover time is around 12 seconds.
:Temperature set by knob C.
:Temperature set by knob B.
:Ambient temperature maintained at around 7°C.
:Stopping the heating immediately (used for power cutoff).
16
C
.
B
A
N
Advertenties
Inhoudsopgave
