The device you have just purchased was submitted to many tests and checks ensuring its quality.
We thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the heater.
Power the heater off before working on it, and check the power supply voltage.
Store the instructionsfor the future reference after installation.
Classification of the heater:
Cat C
: Complies with EU standards for this category.
IP24
: Protected against water projections.
Classe II
: Dual insulation.
1/ Location of the device
- This device was designed to be installed in residen-
tial premises. In any other case, please call your dis-
tributor.
- Installation must comply with the standards cur-
rently enforced in the country of use.
- Locate the heater within minimum distances from
obstacles.
Do not install the device :
• In a draft likely to affect its control (under
centralised mechanical ventilation, etc...).
• Under a fixed mains outlet.
• Inside zones 0 and 1 in bathrooms.
The device is to be installed so that switches
and other controls cannot be touched by a
person in the bath or shower, except in the UK
where
IEE
Regulations
701.512.3 apply. These allow the use of IP24
rated products and their integral controls in
Zone 2 and ouside zones.
We strongly advise against installing vertical machines above an altitude of 1000m
(risk of faulty operation).
Installing a machine at altitude causes an increase in air output temperature
(of the order of 10°C per 1000m above sea level).
It is forbidden to install a vertical machine horizontally or vice versa.
Do not use the device in mobile, on feets or on casters.
(shown on the information label)
I
NSTALLING THE DEVICE
701.512.2
Volume
3
Volume
and
12
Volume
2
1