Maintenance; Draining The Appliance; Opening The Appliance; Installing The Flanged Immersion Heater - Stiebel Eltron SHU 10 SLi Instructies Voor Gebruik En Installatie
Verberg thumbnails
Zie ook voor SHU 10 SLi:
- Instructies voor gebruik en installatie (14 pagina's) ,
- Handleiding voor bediening en installatie (72 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Maintenance
14. Maintenance
WARNING Electrocution
Before any work on the appliance, disconnect all poles
of the appliance from the power supply.
f Dismantle the appliance for maintenance work.
f Observe the tightening torque of the flange screws (see
chapter "Installation / Maintenance / Installing the flanged
immersion heater").
14.1 Draining the appliance
WARNING Burns
Hot water may escape during draining.
f Drain the appliance via its connectors.
14.2 Opening the appliance
f Pull off the temperature selector and the limiting ring.
f Remove the screws from underneath the temperature
selector.
f Open the appliance cover by lowering the bolt screws in-
wards and pivot the cover upwards, then remove it.
SH 10 SLi | SH 15 SLi
f Undo the tie (anti-tip protection).
14.3 Installing the flanged immersion heater
Torque value of the flange screws
20
| SHU 10 | SH 10 | SH 15
Nm
14.4 Checking the protective anode
f Check the protective anode for the first time 2 years after
installation. This requires removal of the flanged immersion
heater. Replace the protective anode if consumed.
f Decide the intervals in which further checks should be car-
ried out.
Fitting the protective anode
f To include the steel cylinder in the equipotential bonding,
observe the order of the fixing elements when fitting the
protective anode.
14.5 Descaling the appliance
Material losses
!
Never treat the protective anode with descaling agents.
f Remove the flanged immersion heater.
f Carefully tap the heating element to remove coarse limescale
deposits.
f Immerse the heating element up to the flange plate in desca-
ling agent.
14.6 Checking the earth conductor
f Check the earth conductor (in Germany DGUV3 for example)
across a water connector and the earth conductor contact of
the power cable.
14.7 Replacing the power cable
The power cable must only be replaced by a qualified contractor
with an original spare part. As an option, you can also use the
following cables:
2 kW appliance
- H05VV-F3x1.0
6±1
f Route the power cable along the cable guide.
www.stiebel-eltron.com
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
