Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
The EUROM TS 1501 infra red heater encloses two parts:
- the real heater with cord, plug and connection piece
- the mounting bracket with dowels, screws etc.
Remove all package material and check the appliance, supply
cord and the plug for signs of damage.
Pay attention to the mounting place for your heater. The
appliance has to be mounted on an incombustible foundation.
That foundation has to be vibrationfree, exact vertical and stable
enough for lastingly holding the appliance free of problems.
Check or the provided dowels and screws are suitable, strong
enough and qualified for the foundation. The material provided is
identified for a brick wall; for another foundation please ask the
specialist for suitable material.
Check before mounting or the minimum safe mounting distances
between heater and environment are strictly followed (see
figures). The distance between the bottom edge of the appliance
and the floor must be at least 2,5 meter. There must be a
distance of at least 0,5 meter between the appliance and the
ceiling, roof or other cover. If the covers consist of flammable
material (p.e. wood, plaster, canvas etc.), the distance has to be
at least 1 meter There must be a distance of at least 1,5 meter at
each side between the appliance and walls or the like (see
figure).
When you install the appliance outside, pay attention that it
doesn't catch excessive wind load.
Fix the mounting bracket totally horizontal on the wall with the
three plugs and screws.
Assemble the appliance onto the mounting bracket with the two
winged nuts.
Adjust the desired angle of radiation. The max. degree to
horizontal is 60° and the minimum degree is 40° (see fig.)
(downstairs).
Fasten all screws another time firmly and scheck or the heater is
firmly mounted. Now your infra red heater is ready for use.
12
Advertenties
Inhoudsopgave
