Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire.
Immerse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer's
instructions.
To reduce the possibility of severe injury, be
s u r e m o u n t i n g / d e m o u n t i n g m a c h i n e i s
anchored to floor. Wear OSHA approved safety
equipment when mounting/demounting tires.
If the tire is to be removed or mounted, the tire changing
machine manufacturer's recommendations must be fol-
lowed in order to reduce possibility of severe injury.
Wheel Installation
To reduce the possibility of component damage, do not
tighten lug nuts to more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the 'cross sequence' pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts in a 'cross
sequence' pattern (Ref Fig. 11 on page 10). Tighten lug
nuts to 50 - 85 ft. lbs. (70 - 115 Nm) torque in 20 ft. lbs.
(30 Nm) increments following the 'cross sequence' pat-
tern.
Tire style
may vary
Ref Whi 1
Fig. 11 Wheel Installation
LIGHT BULB REPLACEMENT
To reduce the possibility of premature bulb failure, do not
touch new bulbs with bare fingers. Use clean, dry tissue
or paper towel to handle the glass portion of the bulb.
For vehicles equipped with lights mounted below cowl,
locate bulb socket on backside of light bar (Ref Fig. 12
on page 10) and turn bulb socket a quarter turn counter-
clockwise to unlock and pull out bulb. Insert new bulb
Page 10
'Cross Sequence'
1
3
2
4
Owner's Manual and Service Guide
(Ref. Capacities and Replacement Parts on page 17)
and rotate socket a quarter turn clockwise to secure.
To replace the tail and brake light bulb, remove hardware
securing lens and remove lens (Ref Fig. 13 on page 10).
Install replacement bulb (Ref. Capacities and Replace-
ment Parts on page 17).
Headlights
Marker
Turn
Light
Signal
Light
Y
Ref Hdr 1
Fig. 12 Headlight, Turn Light and Marker Bulb
Replacement
Tail Light
Bulb
Ref Tlr 1
Fig. 13 Tail and Brake Light Bulb Replacement
Turn Signal
Marker
Light
Light
R G
Rear
Fender
Tail Light
Lens
Advertenties
Hoofdstukken
Inhoudsopgave
