Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Batteries
AA
Always use 4 good quality AA 1.5V alkaline batteries to ensure the best performance of your
product. This product is NOT designed for use with rechargeable batteries. To insert or
change the batteries please follow the steps below:
Remove the compartment
cover from the front of the
Microchip Cat Flap Connect.
After inserting the batteries, the indicator light will initially light up for 2 seconds. Leave the
unit for about 10 seconds before allowing a cat into the tunnel - this allows the electronic
sensors to settle properly.
When the batteries start to run low, the indicator light will flash red once
every 5 secs. Note that this indicator is different from the fast flashing (every
second) when you add a pet.
Buttons & Lights
'Settings' button
Used to connect your Microchip Cat
Flap Connect to your Hub.
'Add a Pet' button
Used to add your cat's microchip ID
or collar tag into the Microchip Cat
Flap Connect (see pages 9-10).
Insert the batteries into the compartment as
shown, with the + and - in the correct orientation.
Then replace the compartment cover.
Indicator light
The light will illuminate when:
- you add a cat (see pages 9-10).
- the batteries are running low (see section
above).
- connecting to Hub.
EN
8
Advertenties
Hoofdstukken
Inhoudsopgave
